What are the techniques for mixing and coloring architectural models?

The coloring step is a very important part of the architectural model, because the color of the architectural model is diversified, and the coloring agent is usually self-painting. The diversification of realistic colors is dizzying, and the self-painting colors on the market are limited. When coloring the building model, there is no required color for self-painting. At this time, you can choose a blended paint. It has the characteristics of strong coverage and strong integration. It is a coloring material with a wide range of uses. What are the techniques for mixing and coloring architectural models?


When mixed paint is used to paint architectural models, it is usually applied by coating. That is, choose some fine-cell foam and dilute it in a small amount, especially on the surface to be treated. Also pay attention to the order. It is usually done radially from the center of the treated surface and should not be chaotic or horizontal. Otherwise, it will affect the uniformity of the colored surface. Don’t rush to find the color when crushing. When the color is lost, you must wait until the paint is completely dry before continuing. If the color method works normally, the effect is basically the same as the self-drawing effect. In the process of coloring with ochre, please pay attention to the following:


One: Operating environment

Since the mixed coating (diluted with a thinner material) requires a long drying time, usually 3-6 hours, it must be handled and dried in a dust-free and well-ventilated environment.

2: The pores of the enamel coating

The foam should be renewed after each vermiculite to ensure that the uniformity of the coloring is not affected.

Three: the color adjustment of the mixed paint

The user should be careful not to mix the alkyd resin and the nitro hybrid paint. The diluted thinner cannot be mixed.


Four: Use two or more colors to mix pigments

Before use, be sure to clean the surface before mixing and keep it dry.