How to make the building model have high realism on the water surface?

The water surface is the setting of the architectural model, and the authenticity of the water surface is a test of the technology of architectural model manufacturers. Among them, different sand table models have different requirements for the water surface, because the water surface model should be tailored according to the style and proportion of the building sand table model. Large areas of water surface and small areas of water surface are different. How to make the building model have high realism on the water surface?

 

 

 

One: When making the water surface with a large scale of the building model, the height difference between the water surface and the ground must be considered. Usually, the generally selected method is to first develop a part of the water surface on the chassis to solve the leakage, and then paste the fully transparent plexiglass mirror or the transparent plastic board with lines on the leakage according to the design concept gradient, and use the blue self-painting on the transparent board. Just spray the color below. This kind of method mainly expresses the water surface, not only the slope of the water surface can be mainly expressed; at the same time, the transparent board has a good simulation effect under the background of the light and the deep blue paint surface at the bottom.

 

 

 

Two: When making the water surface with a small scale of the building model, the slope of the water surface and the ground can be ignored. When making, you can immediately use the blue sticky note to start the tailoring. After cutting, paste it according to its position. The other can be solved by blocking the coloring method. The method is to first stick the blocking film to the surface of the water, and then carry out the omission. After carving, use dark blue self-spray paint to spray color. After the paint is dry, remove the blocking film.